94
•
Beginning behind the valve, place the lower side of the tyre over the edge of the wheel rim.
Pump the tube with a small amount of air until it assumes its round shape, and then insert it
into the tyre.
•
Check to ensure the inner tube is properly positioned all around and is free of folds; if this
is not the case, release some of the air. Now you can easily install the upper side of the tyre
starting across from the valve, using both hands and working towards the valve.
84 85
86 87
•
Check around the tyre on both sides to ensure that the tube is not clamped between the edge
of the tyre and the rim.
•
Push the valve back slightly and then pull it out again to ensure that the tyre is properly seated
in the valve area.
•
Inate the tyre until it can still be pressed easily with your thumb. If the control line on both
sides of the tyre is equally distanced to the rim, the tyre sits centrally. If the tyre does not sit
centrally, let out some air and realign the tyre. Then inate the tyre to maximum operating
pressure (see sidewall) and tighten the dust cap.
To Next Page
Loading...
Need help?
General
