Ovislink Wireless Router - Appendix C: WAN Port Link Status; PPPoE Link Status

OvisLink
- 39
APPENDIX C WAN PORT LINK STATUS
PPPoE link status
“PPPoE offline. Ready to
connect.”
Device’s wan port is not connected to the ISP’s
dialup server. Dialup server for connecting to the
Internet is now available.
"Connecting to server." Device's wan port is now dialing to dialup server.
"Server found." Device dialed to dialup server, and is negotiating
with dialup server.
"Start PPP negotiation." Negotiation is ongoing.
"Authentication (PAP)." Server is verifying the dialup account with PAP
method.
"Authentication (CHAP)." Server is verifying the dialup account with CHAP
method.
"Obtaining WAN IP address." Authentication is successful! Device now is obtaining
IP address from the dialup server.
"Connect successfully." Device dials up to server successfully. User can
connect to internet now.
"Can not find server." Device cannot dial up to the dialup server. Dial-up to
server failed.
"Fail on LCP stage." Configuration for network link failed.
"Authentication (PAP) failure." Failed in authentication; failure was caused by wrong
password.
"Authentication(CHAP)
failure."
Verification on the identity of the device dialup
account failed.
"Fail to Obtain WAN IP
address."
Device cannot obtain IP address from the dialup
server. Dial-up to server failed.
"Server dropped the
connection."
Server cut the device's internet connection.
Device is disconnected to the Internet.
"Disconnect on idle." Device has been idle longer than the idle interval and
was cut off from the connection. The idle
interval value was set in the field "Auto-disconnect if
idle xxx Minutes".
"Connection establish timeout." Device was re-trying to dialing-up to server and
failed. Device finally gave up dialing to the server.