OvisLink
- 4
FACTORY DEFAULT SETTINGS
Password
Default setting: No password.
Setting up password: When configuring the device, press Enter to login the
configuration for the first time. It is recommended that you set a password for security
and management purpose.
Password forgotten? If you forgot the password, you can reset the device to factory
setting. Refer to the section titled “Factory Reset” for details.
Local and Global Port Addresses
The LAN parameters of the product are pre-set in the factory. The default values are
shown below.
Local Port Global Port
IP address 192.168.1.254
Subnet Mask 255.255.255.0
DHCP server
function
Enabled
DHCP client
function is enabled
to automatically get
the Global port
configuration from
ISP.
IP addresses for
distribution to PCs
253 IP addresses continuing from 192.168.1.1 to
192.168.1.253
Table 3: Local and Global Port Addresses
Information from ISP
Before you start configuring this device, you should gather the information as illustrated
in the following tables and keep it for reference.
For CATV dynamic mode:
Adapter Address Some Internet Service Providers (ISP) requires that
you register the MAC address of your network
card/adapter, which was connected to your cable or
DSL modem during installation. If your ISPs require
MAC address registration, find your adapter’s MAC
address by doing the following:
Under Windows 95, 98 or ME : Click Start? Run,
type in “winipcfg”, and select the network adapter (not
PPP adapter).
Under Windows 2000 or XP: Click Start?Run, type
in “command”, and press Enter. At the DOS prompt,
To Next Page
Loading...