To Next Page

To Previous Page

OWC Data Doubler Installation

2.2.5 Late 2008 15” MacBook Pro (5,1) and

Mid-2009 15" MacBook Pro (5,3 and 5,4)

IMPORTANT: be sure that your laptop is fully shut down and disconnected

from all cables, including the power cable. If you have a MacBook Pro

model 5,1 start with Steps 1-3. If you have a MacBook Pro model 5,3 or

5,3, skip ahead to Step 4.

1. Use the release lever (highlighted below in red) to release the battery cover,

then remove it (bottom photo). Recommended: Use the pull-tab on the

battery to remove it from the laptop, then set it aside.

Other manuals for OWC data doubler

Questions and Answers:

Need help?

Do you have a question about the OWC data doubler and is the answer not in the manual?

General