To Next Page

To Previous Page

OWC Data Doubler Installation

12. Once the cables, retainer, and screw have been removed, hold the optical

drive along the edge nearest the cable connectors, then gently lift the

drive out of the optical bay.

Caution: take care to avoid snagging or pulling the cables that were

disconnected in earlier steps. They can tear easily if they catch on the

corners of the drive as you lift it out of the chassis.

Note: the appearance of your drive and optical bay may vary slightly.

Other manuals for OWC data doubler

Questions and Answers:

Need help?

Do you have a question about the OWC data doubler and is the answer not in the manual?

General