Oxy Heli oxy2 - Page 16

Upper Main Shaft
Bearing Block Assembly
Box 1-1/Bag 9
B
A
B
A
26.5mm
Max 10mm
23.6mm
Max 10mm
Left Canopy Assembly
Box 1-1/Bag 11
4 x M1.6x5
Hex Cap Screw
3 x M2x6
Self Tapping Screw
4 x M1.6x5 Hex Cap Screw
Note: Don't fully tighten yet
see assembly alignment Step
page 19.
3 x M2x6 Self Tapping Screw
Note: Don't use any loctite
Lower Main Shaft
Bearing Block Assembly
Box 1-1/Bag 10
OXY2 support two kind of Servo dimension options.
Lower Bearing Block can be installed in two Frame position.
Follow note for Servo type A or B install.
Chapter 7: Main Frame Asembly
Servo type A
use Frame holes A position
Servo type B
use Frame holes B position
OXY0263-Main Frame
OXY0300- Battery Tray
Box 2/Bag 2
page 16
Main Frame Asembly Step 1
OXY0263-Main Frame
Box 1/Bag 11
Main Frame Asembly Step 1