Parameter setup Set up the T10 terminal as follows:
1. Enter the setup mode by pressing the “.” key while power is
applied to the T10 (wait until the two letter prompt appears).
Refer to the terminal manual for more information.
2. Enter the following values:
VW = 4 Default LE = 0 Local Echo OFF
TM = 0 Character Mode EN = 1 Line Terminator (CR)
TD = 0 Turnaround Delay KC = 2 Key Click
BR = 2 Baud Rate (9600) KR = 1 Key Repeat
DF = 4 8 Bits, No Parity CU = 2 Cursor
HS = 0 Default (DTR asserted)
Note: The SC950 must be configured for 9600 baud
(BaudRate = 9600), 8 bit, no parity data formats. Please see
the MA950-LR Reference Manual for additional information on
configuring baud rate.
3-6 MA950
To Next Page