PROBLEM 4: LABEL IS SLANTING
A.
BOTTLE IS NOT EVEN
B.
LABEL IS DIAGONALLY PLACED ON THE BASE PAPER WHEN THE LABELS ARE MADE
C.
THE SLANTING OCCURRED WHEN LABELING. THIS IS CAUSED WHEN THE PEEL PLATE IS NOT
SQUARE TO THE PRODUCT.
PROBLEM 5: NO SCREEN DISPLAY
A.
CHECK IF POWER IS TURNED ON
B.
CHECK IF THE CONNECTION WIRE IS NOT CONNECTED OR DAMAGED
PROBLEM 6: LABEL WILL NOT STICK ON THE PRODUCT
A.
LABEL COMES OUT TOO LATE
1.
Decrease the value of the label peel delay. If value is set to 0 move the physical location of the object
sensor to the left.
B.
LABEL DOES NOT DISPENSE SMOOTHLY
1.
Check whether the PU drive roller with a lock in the label applicator is locked. If not, lock it. If labels
still do not dispense smoothly when locked, check if PU drive roller is locked too tightly by turning the
PU drive roller. If not, loosen the screw in the lock of the PU drive roller and adjust backwards slowly
until it is tight enough when you lock it again.
C.
STEPPING MOTOR
1.
If stepping motor is not running properly, check the wires, belt and other spare parts to see if they
are damaged.
2.
Replace stepping motor if defective.
D.
PRODUCT & LABEL
1.
Check whether the product surface is too wet or slippery or label has incorrect adhesive.
NOTE 1: If problem is found in A or B, you need to improve the bottle or label.
NOTE 2: If the problem is found in C, you need to adjust the applicator peel plate to the appropriate position.
To Next Page
Loading...
