When a pacotizing cycle has been initiated,
PACOJET2 can detect overll immediately when
the pacotizing blade meets the frozen surface. In
thecaseofoverll,onlytheamountforwhichthere
remains ample volume in the beaker is pacotized,
regardless of selected quantities. The pacotiz-
ing task will stop automatically after each needed
interval to allow the operator to remove excess
beaker content until the maximum ll-line level is
achieved.
Despitethisfeature,takecautiontostrictlyadheretonotoverllingpacotizing
beakersabovethemaximumll-line.
Beaker content ll level and portion quantity display during pacotizing5.12
The display screen indicates the programmed por-
tioning details prior to pacotizing and additionally,
duringpacotizing,thellquantityofthebeakerand
the progress of the task. At the end of the task, the
pacotizedquantity andthe non-pacotizedquantity
remaining in the beaker are also indicated. This dis-
play will clear when the protective outer beaker is
dismounted from the machine.
Should the number of programmed portions not be fully pacotized due to
insufcientllcontent,theremainingnumberofoutstandingportionswillbe
indicatedonthedisplayscreen.Inthiscase,thedisplay,andconsequently,
the programming of the task are retained, even after the protective beaker has
been dismounted and can thus be used as a presetting for processing a sec-
ond beaker to complete the outstanding amount of portions programmed.
Onecanresetthedisplayindicatinganyremainingquantitiesbypressingthe
STOP/RESET/HOME button.
Machine control and assistance function when pacotizing overlled 5.13
beakers
A pacotizing cycle can increase the volume of a beaker’s initial content up
to 30%, depending on the preparation of the food and the pressure setting.
Therefore,thepacotizingbeakermustneverbelledoverthemaximumll-
line as indicated on the pacotizing beaker.
In order to prevent damage caused by improper use through neglecting the
lllimitationdirections,thePACOJET2isequippedwithacontrolandassist-
ance function.