Cleaning accessories7.9
The parts listed below can be cleaned in a dishwasher:
Pacotizing beaker of chrome-steel•
Protective outer beaker•
Pacotizing blade•
Spray guard, black•
Sealing ring, blue•
Rinsing insert, green•
Spatula•
In order to prevent the accumulation of germs, the pacotizing blade and the
spray guard must be:
rinsed in order to remove general residue•
soaked in a cleaning/disinfectant solution to kill any germs and then•
rinsed under water or through a dishwasher •
The pacotizing blade will remain rust-free with proper care. It should be han-
dled as one would a meat-grinding blade to prevent the development of rust.
Afterthepacotizingbladehasbeencleaned,itiseasytoapplyalmofoil.
A food-safe oil or lubricant must be used.
Beaker lids should only be cleaned in a dishwasher under certain condi-
tions to preserve the integrity of their shape. They are temperature resistant
between −25°C and +85°C. Please verify the temperature range of your
dishwasher before using it to clean beaker lids.
What to do when8
? PACOJET2 stopped the processing cycle, though the desired quantity
has not been or only partially processed.
The display screen shows “error”.
The processing cycle could not be completed due to a machine overload.
Power off the machine using the ON/OFF switch.
After approx. 5 seconds, power on the machine.
If the PACOJET logo is shown on the display, fol-
lowed by the programmed processing mode, con-
tinue processing further beakers.
If he display screen continues to show “error” af-
ter you have powered the machine off and then on
again, the mechanical overload protection device
has been activated. Contact your authorised serv-
ice provider.
! PACOJET2 can overload if the machine cannot process the specic
food preparation.
Possible causes can be:
temperatureofthefoodpreparationistoocold(lessthan−23°C)•
food preparation has thawed and does not adhere to the inner beaker sur-•
face
pacotizing blade is blunt or deformed•
specicfoodpreparationcannotbeprocessedbyPACOJET2•
To Next Page
Loading...
