pg. 11
WK-1x User Guide
2. Rotate the WAP counter-clockwise until the T-bar bracket is secured to the T-bar.
WK-1-O Installation
1. Place the unit in an appropriate place using the mounting kit.
2. Run an Ethernet cable to the device and plug one end into the WK-1-O access point.
3. Plug the other end of the Ethernet cable into a PoE+ injector or PoE+ Switch.
4. The LED lights will begin to light up and indicate that WAP is connected.
5. Once the WAP fully boots up, you may log into the WAP and configure the settings.
Antennas
To Next Page
Loading...
