Palfinger ILP 33 - Lubrication

ILP 25/33 Owner’s Manual
Rev.1.4 18
7.2 Lubrication
Properly lubricated, the ILP series Palfinger Liftgates will ensure longevity. Lubricate the liftgate at the same
time as the truck/trailer. Grease more frequently if the liftgate is frequently used. The liftgate should be
greased every 500 cycles (depending on use – estimated every 3 month).
All bearing points must be lubricated in accordance with the maintenance intervals.
Reminder: Lubricate all points with the platform at ground level.
-Platform Hinges
-Cart Stops (If, installed)
4 zerks:
- 1 Cylinder
- 2 Lift arm
- 1 Parallel arm
4 zerks:
- 1 Cylinder
- 2 Liftarm
- 1 Parallel arm
4 zerks:
- 1 Cylinder
- 1 Parallel arm
- 2 Shackle
4 zerks:
- 1 Cylinder
- 1 Parallel arm
- 2 Shackle
Open enclosure to
check and refill oil.
Grease: Location of Grease Zerks (8 on each side, 16 total)
IN
OUT
Oil: Oil level in the power pack tank (see marking inside of power pack reservoir)
IN
Lubricate: Platform hinges, Slide Rails and optional Cart Stops.