109
Operator positions
for hand cable
control
DANGER!
Crushing hazard due to wrong operator position!
If the operator does not stand in the correct position when
moving the platform via the hand cable control, personal in-
jury and material damage may occur .
Make sure to stand in the correct position (see the picture
below) when operating the platform with the hand cable
control. Do not stand in another position.
When operating the platform with the hand cable control
while standing inside the vehicle, always keep a minimum
distance of 250 mm from the sill.
Do not stand in the squeezing area where the platform ap-
proaches the vehicle body.
Exclusively stand in the platform area marked with the foot
symbols in the illustration when moving the platform.
When standing on the ground for operating the platform,
keep a minimum distance of 1 m from all platform rims.
Make sure that you can see the entire working area and
that no other person stays on or near the platform.
1 m
1 m
1 m
250 mm
Betriebsanleitung_Hubladebuehnen_EN.book Seite 109 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
