144
Quarterly or Semi-annual Maintenance
Lubricating the Low-maintenance Bearings
Clean the low-maintenance bearings and, if required, the
guide rails.
Grease the low-maintenance bearings and, if required, the
guide rails with lubricant grease.
Note: If you use the tail lift quite frequently, the low-maintenance
bearings and, if required, the guide rails must be greased
more frequently than once a year.
Moving the Tail Lift
After a standstill of more than 3 months you have to move the
tail lift several times.
Open, lift, lower and close the tail lift using the correspond-
ing operating element.
Repeat this procedure approximately 5 times.
Annual Maintenance
Changing the Hydraulic Oil
CAUTION!
Risk of injury or material damage through waste oil!
If you do not change the oil in the hydraulic unit once a year,
condensation water could accumulate, especially at tempera-
tures below the freezing point. This disturbs the function of
the tail lift. Persons could be injured and material could be
damaged.
Change the hydraulic oil once every year.
Preferably change the oil shortly before the start of the
winter season.
Betriebsanleitung_Hubladebuehnen_EN.book Seite 144 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
