136
Applying Wax Spray to the PC Board
To protect the contacts against corrosion.
Depending on the weather conditions and especially after
exposure to salt water spray, apply wax spray to the PC
board and the connector plugs.
Greasing and Lubricating
Grease the conical lubricating heads and, if applicable, the
guide rails as required and after each cleaning with a pres-
sure washer.
When lubricating the plastic plain bearings, spray the
lubricat-
ing oil (
see chapter “Lubricants and Operating Media” from
p. 188) into the bearings from the side.
To grease and lubricate:
Move the platform to its parking position.
Clean the plastic plain bearings.
Spray lubricating oil into all 8 plastic plain bearings from
both sides.
Apply 1 or 2 spray portions to each side of a plastic plain
bearing.
Allow the lubricating oil to take effect for 1 to 2 minutes.
Open, lower, lift and close the platform for at least three
times. Make sure to use the full range of functions.
The lubricant is distributed in the plain bearings.
Repeat the lubricating procedure as required.
Clean all surfaces that are soiled with lubricant.
Checking/Refreshing Platform Marks
The marks on the platform must always be in a good condition
and clearly visible. The indicate the payload center of gravity
and the operator position on the platform when operating the
tail lift by using the hand cable control.
Check the marks for good visibility and refresh them if re-
quired with abrasion-resistant paint.
Betriebsanleitung_Hubladebuehnen_EN.book Seite 136 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
