49
with the “E-b” symbol on the display, the
battery does not have enough power for
a test. You must change the battery before
using the meter.
Battery Replacement
When replacing the batteries, make sure the
meter is turned off.
STEP 1: With the meter off, press the buckle on
the battery cover and lift up to open the cover.
STEP 2: Remove the old batteries and replace
with new ones. Be sure to align the batteries
properly.
STEP 3: Close the battery cover. If the meter
does not power on after you have replaced the
batteries, check that the batteries are correctly
installed.
STEP 4: Turn the meter on by pressing the “M”
button to check the time and date. Replacing
the batteries does not affect the meter’s memory
(previous test results stored in the memory).
However, the date and time settings may need to
Palmdoc 2 User Man.indd 49 24/08/2017 10:49
To Next Page
