23
Setup Steps
The PalmDoc II meter has several different settings
that may need to be adjusted before using the
meter. You should check the time and date each
time the batteries are replaced.
STEP 1: Insert the Batteries
Open the battery cover located on the backside
of the meter. Insert two (2) AAA Alkaline batteries
and align them properly. The meter will turn on
and enter Setting Mode.
STEP 2: Enter Setting Mode
If your meter is off, press the “SET” button located
in the battery compartment. The meter is now in
the setting mode.
Voice Speaks: “Your meter is on. Please wait.
Setting mode.”
STEP 3: Setting Volume Level
• Numbers 1 to 3 indicate
speaking volume from low to
high, where “ ”
is displayed on the LCD
Figure 6
Palmdoc 2 User Man.indd 23 24/08/2017 10:49
To Next Page
Loading...
