FOREST CRANE PALMS 840
V 1.03 EN 2012 Palmse Mehaanikakoda LLC 24
7. DETACHING FOREST CRANE
Choose sufficiently hard and even level ground for detaching forest crane. Ensure, that no
unauthorized persons are around crane during detaching and storing process. When
storing control valve, make sure it is out of the reach of children.
Lower the support legs to support crane properly.
Fix crane firmly by proper hoist.
Make sure that crane can not lean or fall over.
Detach quick couplings and put covers on them.
Always switch the pump off before disconnecting quick couplings!
Detach crane from the vehicle.
8. STORAGE INSTRUCTIONS
Clean forest crane and if necessary, repaint any points, where paint has peeled off or
gets damaged, this will avoid rust.
Lubricate forest crane thoroughly (see lubricating instructions).
Do not leave electric operated and pilot operated valve controls uncovered, water and
moist may damage wiring and contacts.
Release pressure from the cylinders.
Protect the cylinder piston rods and exposed parts of the control valve with grease.
Store forest crane in a sheltered area (under the roof), avoid direct contact with the
ground.
To Next Page
Loading...