FOREST CRANE PALMS 840
V 1.03 EN 2012 Palmse Mehaanikakoda LLC 37
12. WARRANTY
The machine shall not be taken into use before the operating manual is thoroughly
read and understood.
Duration of warranty:
Parts manufactured by Palmse Mehaanikakoda LLC, warranty is three years.
Hydraulic components, sliding bearings, cylinders, rotators, pumps, valve blocks and
all other parts and equipment not manufactured by Palmse Mehaanikakoda LLC,
manufacturer warranty applies.
The warranty does not apply:
to any faults or defects arising from normal wear, negligence or improper operation.
to faulty installation or incorrect or inadequate maintenance.
if during maintenance or repairs were not original or same quality level as originals
spare parts used.
The warranty is invalidated:
if any repairs or constructional changes to the warranted products have been made
by others than the manufacturer or a service shop authorized by the manufacturer or
if the equipment has been altered without co-ordination with manufacturer.
if the settings of the pressure relief valves of the loader’s directional control valves
have been changed without co-ordination with manufacturer.
Palmse Mehaanikakoda LLC will be not responsible for any damages caused by the
improperly handled machine.
The manufacturer will not assume any liability for any economical losses or for any
consequential damage to persons or property, which may incur during product’s usage or
failure.
Product warranty is NOT VALID in case of user’s incompetence and/or irrespective
handling of the equipment. Warranty does not cover transportation cost, repairing labor or
loss of profit due to normal abrasion or product failure.
Manufacturer:
Palmse Mehaanikakoda LLC
Võsupere
Lääne-Virumaa
45 202 Estonia
Tel +372 32 55 375
Fax +372 32 55 378
info@palms.eu
www.palms.eu
To Previous Page
Loading...