Panasonic AG-DVX100BP - DIAGNOSTIC MENU (VCR Mode); How to Display the Error Rate

INF-12
5-2. DIAGNOSTIC MENU (VCR mode)
5-2-1. How to display the Error Rate.
This unit can be displayed Error Rate and it shows the playing condition of the VCR.
In case of the error rate is displayed, BER DISPLAY and SAMPLE SPEED mode is select on DIAGNOSTIC menu.
How to confirm the Error rate.
1. Select the TOTAL in item of BER DISPLAY.
2. Record the color bar signal on LP mode and playback the recorded portion. Confirm that the number of bar on
display within 10 bars or less. The less bars displayed the better the error rate.
TOT
When selecting TOTAL in BER DISPLAY
mode, it is displayed “TOT” and if select
VIDEO, it is displayed “VID” and if select
AUDIO, it is displayed “AUD”.
TOT
CH1
CH2
The color of the bar
In case of green display: Error rate is good
In case of red display: Error rate is bad
CH1
CH2
Select SLOW or FAST by OPERATION LEVER
and press SET(STILL) of OPERATION LEVER.
Factory default setting is “SLOW”.
DIAGNOSTIC MENU
BER DISPLAY OFF
SAMPLE SPEED SLOW
DIF INFO OFF
CYLINDER 10000H
TAPE RUN 10000H
THREADING 10000T
PUSH MENU TO EXIT
DIAGNOSTIC MENU
BER DISPLAY TOTAL
SAMPLE SPEED SLOW
DIF INFO OFF
CYLINDER 10000H
TAPE RUN 10000H
THREADING 10000T
PUSH MENU TO EXIT
OFF
VIDEO
AUDIO
TOTAL
SLOW
FAST
Select the item BER DISPLAY and press
SET(STILL) of OPERATION LEVER.
Select VIDEO, AUDIO or TOTAL b
y
OPERATION LEVER and press SET(STILL) o
f
OPERATION LEVER.
Factory default setting is “OFF”.
A
fter selecting BER DISPLAY mode, move to
item of SAMPLE SPEED by tilt the
OPERATION LEVER in the DOWN (
■
:STOP)
direction.
The Audio Level Meter is change to error rate
display, when returning to the normal screen.
NOTE:
The display screen is changed only in the VCR
mode.