Panasonic AG-DVX100BP - Removal of LCD Unit

DIS-11
11. Removal of LCD Unit
1. Remove the Side Case R S Unit.
2. Unscrew the screw (Q) and remove the SHIELD
PLATE.
3. Remove the SHEET as shown in figure.
4. Unscrew the 2 screws (R) and remove the HINGE
COVER.
5. Disconnect a connector P4671 on R-SIDE C.B.A..
NOTE: Please match the hole of flexible cable and
projection of Side Case when you put the
SHEET.
6. Unscrew the 2 screws (S) and remove the LCD
Unit.
SCREW (Q)
SILVER
4mm
SCREW (Q)
SHIELD PLATE
BLACK
6mm
SCREW (R)
SCREW (R)
SHEET
P4671
SCREW (R)
Match the hole and projection
5mm
SCREW (S)
SCREW (S)
HINGE COVER
LCD UNIT
SILVER