Panasonic AG-DVX100BP - Removal of CAMERA C.B.A; Removal of Lens Unit; Removal of Zoom Motor Unit

DIS-12
12. Removal of CAMERA C.B.A.
1. Remove the Side Case R S Unit.
2. Disconnect connector P1004 and P1006 on
CAMERA C.B.A..
3. Unscrew the 4 screws (T) and remove the
CAMERA C.B.A..
NOTE: When removal of the CAMERA C.B.A., the
connector P1009 is disconnected (P1009 is
connected between CAMERA and BACK
CONNECT C.B.A.). Be careful not to
damage the connector P1009.
Check the connector has been connected
securely when the CAMERA C.B.A. is
installed.
Moreover, please do not hit the CAMERA
C.B.A. to the plate in this side when you
remove or install the CAMERA C.B.A..
13. Removal of Lens Unit
1. Remove the CAMERA C.B.A..
2. Unscrew the 4 screws (U) and remove the Lens
Unit.
NOTE: When installing a Lens Unit, set the ZOOM
SW to SERVO position.
14. Removal of Zoom Motor Unit
1. Remove the Lens Unit.
2. Soldering is removed on the zoom motor.
3. Unscrew the 2 screws (V) and remove the Zoom
Motor Unit.
NOTE: Match the hole (A) and projection of Lens
Unit as shown in figure and tighten the 2
screws (V) in installation of Zoom Motor
Unit.
SILVER
4mm
SCREW (T)
P1004
SCREW (T)
P1006
P1009
SCREW (T)
CAMERA
C.B.A.
LENS UNIT
SILVER
4mm
SCREW (U)
SCREW (U)
Hole (A)
5mm
SILVER
SCREW (V)
Unsolder
ZOOM MOTOR UNIT
SCREW (V)