EasyManua.ls Logo

Panasonic AG-UX180 - Manual Focus Assist

Panasonic AG-UX180
236 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 60 -
Peaking may not be displayed when you use Digital Zoom (l 89). To zoom in and use peaking at
the same time, we recommend increasing the magnification level of the magnified display by
setting [FOCUS ASSIST 1] to [BOTH] or by using the magnified display and the peaking function
in combination.
(Notes on the peaking of Focus Assist)
When EVF/LCD detail is enabled, Focus Assist is canceled. (l 54)
(Notes on the magnified display of Focus Assist)
Some information on the screen disappears when the screen is magnified.
In the following cases, the screen is not magnified during Focus Assist:
j During motion picture recording or PRE-REC (l 97, 187)
j When using Digital Zoom
j When using Area Mode (l 92)
j During auto recording (l 100)
j During Super Slow Recording (l 106)
j In Variable Frame Rate Mode (l 103)
j During AG ROP application connection (l 146)
If you set the magnification level of the magnified display to 5.5k or higher, peaking may not be
displayed when using i.Zoom (l 49).
Manual Focus Assist
Focus is automatically adjusted after you adjust it with the focus ring in Manual Focus Mode.
Focus may not be achieved when the focus deviation is great.
After automatic adjustment is complete, the focus is not adjusted automatically again until you
operate the focus ring.
Switch to Manual Focus Mode. (l 53)
1 Select the menu.
Touch [EXIT] to complete the setting.
The on-screen icon changes from [MF] to [MA].
2 Adjust the focus by rotating the focus ring.
Focus is automatically adjusted after you adjust it with the focus ring.
The color of the on-screen icon for the focus value changes during automatic adjustment.
This function is not available in the following cases:
j When Auto Focus is used
j During Super Slow Recording (l 106)
j In Variable Frame Rate Mode (l 103)
The on-screen icon changes to in the macro range.
Manual focus assist does not work in following cases:
j When adjusting the focus with the remote control (commercially-available) (l 128)
: [SW SETUP] # [MF ASSIST] # [ON]
MENU
AG-UX180ED(DVQP1171ZA)_E.book 60 ページ 2016年11月28日 月曜日 午前11時32分

Table of Contents

Other manuals for Panasonic AG-UX180

Related product manuals