Panasonic AG-UX180 - Setting the External Output Resolution

- 132 -
≥ This item is set to [OFF] in the following situations when this unit is in Recording Mode:
j When [REC FORMAT] is set to a setting with a size of 4K (4096k2160) or UHD (3840k2160)
(l 165)
j During auto recording (l 100, 192)
Setting the external output resolution
Change the setting for outputting images to an external monitor or other external device (recorder,
etc.).
1 (If using )
Select the [OUTPUT SEL] menu.
2 Select the [RESOLUTION] menu.
≥ [SYSTEM] automatically sets the output resolution according to the setting in [REC FORMAT].
If the images are not output on the external device when the setting is [SYSTEM], switch to the
method [1080p], [1080i] or [DOWN CONV.] which enables the images to be displayed on your
external device. (Please read the operating instructions for the external device.)
≥ [DOWN CONV.] outputs images in standard picture quality.
≥ (If using )
To connect with an AV cable (commercially-available), select [DOWN CONV.].
: [OUTPUT SETUP] # [OUTPUT SEL] # desired setting
[HDMI]: Select this setting when connecting to the HDMI OUT terminal.
[SDI]: Select this setting when connecting to the SDI OUT terminal.
[AV]: Select this setting when connecting to the AV OUT terminal.
: [OUTPUT SETUP] # [RESOLUTION] # desired setting
[SYSTEM]/[1080p]/[1080i]/[DOWN CONV.]
AG-UX180
MENU
MENU
AG-UX170
AG-UX180ED(DVQP1171ZA)_E.book 132 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分