Panasonic AG-UX180 - White Balance

- 64 -
Automatic White Balance function may not reproduce natural colors depending on the scenes or
lighting conditions. If so, you can adjust the White Balance manually.
≥ Register [AWB] to a USER button. (l 84)
This function is registered to the USER9 button by default.
≥ Switch to Manual Mode. (l 45)
1 Press the WHITE BAL button to switch to [Ach], [Bch], or [PRST].
≥ The setting changes each time you press the button.
[Ach] # [Bch] # [PRST]
≥ If you switch to [PRST], the White Balance mode set in [WB PRESET] will be displayed.
2 (If you have switched to [PRST])
Press the USER button to which [AWB] is registered or touch the applicable
USER button icon to change the White Balance mode.
≥ The mode will change each time you press the USER button to which [AWB] is registered or
touch the applicable USER button icon.
[P3200K] # [P5600K] # [VAR]
≥ It is not possible to change the White Balance mode without registering [AWB] to a USER button.
≥ If you set the White Balance mode to [ATW] in by following either of the procedures below, the
White Balance mode cannot be changed even if you press the USER button to which [AWB] is
registered or touch the applicable USER button icon.
j Pressing the USER button to which [ATW] is registered (l 84, 89)
j Pressing the WHITE BAL button to switch to the item (Ach/Bch/PRST) setting in [ATW SET]
(l 174)
Recording
White Balance
A White Balance
B Color temperature display
≥ Displayed when the White Balance mode is set to Ach or Bch.
≥ The color temperature display is not guaranteed to indicate an exact value. Use the indicated
value only as a guide.
1 Jog dial
2 WHITE BAL button
ヴユロバ
ヱヶヴラ
ヴユヵ
WHITE BAL


5600K


Ach
AG-UX180ED(DVQP1171ZA)_E.book 64 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分