- 61 -
Focus Transition
You can use Focus Transition by registering [FOCUS TRANS] to a USER button. With Focus
Transition, you can shift the current focus position to a pre-registered focus position.
≥ Please refer to page 84 for details about setting the USER button.
To use Focus Transition, you need to register a focus position.
≥ You can register up to 3 focus positions.
≥ Switch to Manual Focus Mode. (l 53)
1 Select the menu.
2 Touch the item to which you want to register the focus position.
≥ You can select the item by pressing the USER buttons 1s3.
≥ The Focus Assist screen will be displayed.
≥ The screen may not be magnified depending on your settings.
3 Adjust the focus by rotating the focus ring.
4 Touch [ENTER].
≥ The icon of the item to which the focus position has been registered will be highlighted in yellow.
≥ To select a different item, perform the operations in Steps 2
s4.
5 Touch [EXIT] to complete the setting.
≥ The focus positions of the items you have set will be registered.
≥ This function is not available in the following cases:
j When Auto Focus is used
j During Freeze Frame (l 91)
j During Super Slow Recording (l 106)
j In Variable Frame Rate Mode (l 103)
≥ The focus position settings are canceled in the following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j If you operate the zoom
j If you enable or disable Infrared Recording Mode
Registering a focus position
: [RECORD SETUP] # [FOCUS TRANSITION] # [SET]
[1]/[2]/[3]
AG-UX180ED(DVQP1171ZA)_E.book 61 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分
To Next Page
Loading...
