EasyManua.ls Logo

Panasonic AG-UX180 - Page 62

Panasonic AG-UX180
236 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 62 -
Select the [FOCUS TRANSITION] menu. (l 61)
Register [FOCUS TRANS] to a USER button. (l 84)
1 Switch to Manual Focus Mode. (l 53)
2 Press the USER button to which [FOCUS TRANS] is registered or touch the
applicable USER button icon.
3 Touch a registered item ([1]s[3]).
Focus Transition will start. Focus will shift slowly from the
current position to the registered position. This will take a
few seconds. (l 63)
As the focus shifts, the Focus Transition bar will move
from [S] to [E].
4 Touch [EXIT] to exit Focus Transition.
If you move this unit a lot after setting the focus position, focus may not stop at the set position.
When Focus Transition is in use, focus cannot be adjusted with the focus ring.
Focus Transition is not available in the following cases:
j When Auto Focus is used
j During Freeze Frame (l 91)
j During Super Slow Recording (l 106)
j In Variable Frame Rate Mode (l 103)
j When color bars are displayed. (l 109)
j When a remote control (commercially-available) is connected (l 128)
j During AG ROP application connection (l 146)
Focus Transition settings are canceled in the following cases. To use Focus Transition again,
register a focus position again. (l 61)
j If you turn the unit off
j If you press the THUMBNAIL button
j If you operate the zoom
j If you enable or disable Infrared Recording Mode
When Focus Transition is in use, only the USER button functions below are available. Press the
applicable USER button (one of the USER buttons 5 to 9 button) to use them. (l 86)
j [FOCUS ASSIST 1]
j [FOCUS ASSIST 2]
j [FOCUS TRANS]
j [IR REC]
j [BACKGROUND]
j [PRE-REC]
j [USB MODE]
j [EVF ON/OFF]
j [AUTO REC]
j [MENU]
You can switch between the items or exit Focus Transition by pressing the USER buttons 1
s4.
When using Focus Transition, functions registered to the USER buttons 1
s
4 do not work with the USER buttons.
Using Focus Transition
A [EXIT]
B Focus Transition bar
SE
1
2
3
MF 50
MF50MF50
USER button Corresponding setting
USER1 to USER3 [1] to [3]
USER4 [EXIT]
AG-UX180ED(DVQP1171ZA)_E.book 62 ページ 2016年11月28日 月曜日 午前11時32分

Table of Contents

Other manuals for Panasonic AG-UX180

Related product manuals