- 70 -
Gain adjustment
≥ Use the jog dial to change the settings.
≥ Switch to Manual Mode. (l 45)
1 Press the GAIN button to switch to [LOW GAIN], [MID GAIN], or [HIGH GAIN].
≥ The setting changes each time you press the button.
[LOW GAIN] # [MID GAIN] # [HIGH GAIN]
≥ It is possible to register gain values to [LOW GAIN], [MID GAIN], and [HIGH GAIN] and switch
between these values. (l 172, 173)
≥ It is also possible to switch to the desired gain value by pressing the USER button to which
[LOW GAIN], [MID GAIN] or [HIGH GAIN] is registered. (l 108)
2 Push the jog dial.
3 Adjust the gain by rotating the jog dial.
Gain value:
0 dB to 24 dB
≥ Value closer to 0 dB darken the image.
≥ Value closer to 24 dB brighten the image.
≥ When [EXTENDED SENSITIVITY] is set to [ON], you can set a value between -3 dB and 24 dB.
(l 169)
≥ The selected gain value is not maintained if any of the following operations is performed:
j Pressing the GAIN button
j Switching to Auto Gain Mode
j Switching to Infrared Recording Mode (l 94
, 187)
≥ Auto Gain Mode is activated when one of the following operations is performed:
j Setting [AGC] to [ON] and switching to Auto Mode
(l 45)
j Setting [LOW GAIN], [MID GAIN] or [HIGH GAIN] to [AUTO] and then pressing the GAIN
button to switch to the applicable gain setting.
1 Jog dial
2 GAIN button
A Gain value
≥ In Auto Gain Mode, “AGC” is displayed; in Manual Gain Mode, the gain value is displayed in dB.
B [GAIN]
AG-UX180ED(DVQP1171ZA)_E.book 70 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分
To Next Page
Loading...
