– 170 –
Chapter 8 Connecting to External Devices — Connection function via <USB2.0 DEVICE> or <USB3.0 HOST> terminal
2
Move the cursor to the card slot number of the copy source and press the control stick.
For [TYPE S], selecting [ALL SLOT] exports all cards currently inserted.
3
Select [YES] in the confirmation message and press the control stick.
Exporting begins. A progress bar appears during exporting. (Fig. 1)
[COPY COMPLETED!] will be displayed when exporting is completed.
@@
NOTE
t For export with [TYPE S], P2 card data and copied data can be veried (compared) automatically after exporting. Verication at the time of export
is enabled in the factory setting. When you set to disable verication at the time of export, exported data is not veried, and the time until export
completes will shorten. To disable verication, set [VERIFY] to [OFF] in the main menu → [CLIP] → [STORAGE COPY SETUP]. For [FAT], verication
is not performed regardless of this setting.
t To discontinue the export process, press the control stick. A [CANCEL] conrmation message will appear. Select [YES] and press the control stick.
t Even if you cancel the process during verication, copying to the P2 card will continue until it is completed.
t microP2 memory cards that exceed 32 GB cannot be exported and imported. Use copied clips.
Copying to a storage device by clip
You can copy only the selected clips to a storage device.
1
Go to the thumbnail screen. Use the control stick to place the cursor on a clip you want to copy and press the control stick.
You can also select multiple clips.
2
Select [STORAGE] in the main menu → [CLIP] → [COPY] and press the control stick.
A list of folders or partitions in the storage device is displayed.
3
Select the copy destination and press the control stick.
4
Select [YES] in the confirmation message and press the control stick.
This starts the copying process. A progress bar is displayed during copying.
[COPY COMPLETED!] will be displayed when copying is completed.
@@
NOTE
t When the storage device has a [FAT] le system, the folders displayed are as follows:
- Root
- Folders down to the third level including the CONTENTS folder
t To copy to a [TYPE S] storage device, one or more partitions are required. You can either format the storage device to [FAT] or perform copying after
creating a partition through the export process.
t To cancel the copy process, use the control stick to place the cursor on [CANCEL] and press the control stick. A [CANCEL] conrmation message will
appear. Select [YES] and press the control stick. Clips copied halfway to the copy destination are deleted.
t If you have copied clips to a [TYPE S] storage device, you will not be able to import to that partition by card. Also, the part number display of the card
at that instance will display [UNKNOWN].
Storage device information display (explorer screen)
You can perform the following operations in the explorer screen display.
f Storage device information display
f Storage device partition or folder thumbnail display and selection
f Target partition or folder selection
To display the explorer screen, select [STORAGE] in the main menu → [CLIP] → [EXPLORE] and press the control stick.
2
3
4
1
1 Storage device indicator
This displays the connected / not connected status and the storage device type.
2 Display mode
This indicates that the explorer screen of the storage device is currently displayed.
3 Device information
For [TYPE S] and [P2STORE] (storage devices that allow reading/writing by card)
[PARTITION] [TYPE S]/[P2STORE]
[VENDOR] Vendor name
To Next Page
Loading...
