Panasonic AJ-PX270 - Page 171

– 171 –
Chapter 8 Connecting to External Devices — Connection function via <USB2.0 DEVICE> or <USB3.0 HOST> terminal
[MODEL] Model name
[SIZE] Total capacity (unit: GB)
[USED]
Used capacity (unit: GB)
Used P2 card area (unit: number of clips), maximum of 23
[FREE CAP.] Remaining capacity (unit: GB)
[SELECTED PART.] Number of partitions selected
For [FAT] and [OTHER] (other storage devices)
[PARTITION] [FAT]/[OTHER]
[VENDOR] Vendor name
[MODEL] Model name
[SIZE] Total capacity (unit: GB)
[FREE CAP.] Remaining capacity (unit: GB)
[SELECTED PART.] Number of folders selected
4 Partition or folder information
For [TYPE S] and [P2STORE] (partition information)
Displays a checkmark when a target partition is selected
[NO.] Partition number
[MODEL] P2 card model name
[PARTITION NAME] Name assigned to the partition
[DATE] Partition record date
[TIME] Partition record time
[SERIAL] P2 card serial number
For [FAT] and [OTHER] (folder information)
Displays a checkmark when a target partition is selected
[NO.] Folder number
[FOLDER NAME] Folder name (excluding the CONTENTS folder)
[DATE] Folder creation date
[TIME] Folder creation time
@@
NOTE
t For [TYPE S] storage devices, you can switch the display between the partition name and serial name using the control stick.
t If there is an invalid partition in [P2STORE], the partition information is displayed in gray.
t The remaining free space of the corresponding partition can be checked in the main menu → [CLIP] → [PROPERTY] → [FREE CAP. OF
PARTITION].
Selecting the target folder/partition in the explorer screen
You can display all clips included in the selected partition/folder as thumbnails by selecting partitions/folders as targets. You can display up to six
partitions/folders. When the seventh partition/folder is specied, setting is disabled and a warning is displayed.
Fig. 1
1
In the explorer screen, place the cursor on the partition/folder.
2
Press and hold the control stick (for one second or more).
The partition/folder is selected and a checkmark is displayed. (Fig. 1)
The selected target partition/folder is valid until the storage device is disconnected or the power is turned off. To release the selected partition/folder,
hold down the control stick (for one second or more) again on the selected partition.
Press the <CANCEL> button to deselect all partitions/folders.