16
Setting the Supervisor Password (enabling, changing, disabling)
Your password will not be displayed on the screen.
Limit your password to seven characters. Note that there is no distinction
between upper and lower case letters.
White colored keys can be used. Note that the space bar and function keys
cannot be used.
Do not input your password while holding down on Shift or Ctrl .
Use only the upper horizontal row of numeric keys to input your password.
Do not forget your password. If your Supervisor Password is forgotten you will
be unable to use your computer. Contact Panasonic Technical Support.
When running the Setup Utility, do not leave your computer even for a short
time.
Security Measures
1
Run the Setup Utility ( page 41)
2 Using and , select [Security]
3 Using and , select [Set Supervisor Password], then press
Enter
4 <Only when the Supervisor Password has been set>
Enter your password at the [Enter Current Password], then
press Enter
5 Enter your password at the [Enter New Password], then press
Enter
To disable the Supervisor Password
Press only Enter
6 Re-enter your password at the [Confirm New Password] , then
press Enter
To disable the Supervisor Password
Press only Enter
7 At the [Setup Notice], press Enter
8 Press F10 , then select [Yes]
When you do not want the User Password enabled, changed, or disabled
without permission,
1 Using and , select [User Password Protection] and press Enter .
2 Using and , select [Protected] and press Enter .
CAUTION
NOTE
To Next Page
Loading...
