17
Setting the User Password (enabling, changing, disabling)
Security Measures
Your password will not be displayed on the screen.
Limit your password to seven characters. Note that there is no distinction
between upper and lower case letters.
White colored keys can be used. Note that the space bar and function keys
cannot be used.
Do not input your password while holding down on Shift or Ctrl .
Use only the upper horizontal row of numeric keys to input your User Pass-
word.
Do not forget your password. If a password is forgotten, you will be unable to
use your computer. Contact Panasonic Technical Support.
When running the Setup Utility, do not leave your computer even for a short
time.
To prevent the changing of your password without permission
Set the User Password Protection option ( page 16).
1 Run the Setup Utility ( page 41)
2 Using and , select [Security]
3 Using and , select [Set User Password], then press Enter
4 <Only when the User Password has been set>
Enter your password at the [Enter Current Password], then
press Enter
5 Enter your password at the [Enter New Password], then press
Enter
To disable the User Password
Press only Enter
6 Re-enter your password at the [Confirm New Password] , then
press Enter
To disable the User Password
Press only Enter
7 At the [Setup Notice], press Enter
8 Press F10 , then select [Yes]
Set the Supervisor Password if you have not done so. ( page 16)
NOTE
CAUTION
To Next Page
Loading...
