Panasonic CF-27 Series

To Next Page

To Previous Page

Setting the Hard Disk Lock (enabling, disabling)

Before changing the hard disk, be sure to set the [Hard Disk Lock] of the Setup

Utility to [Disable].

1 Run the Setup Utility ( page 41)

2 Using and , select [Security]

3 Using and , select [Hard Disk Lock], then press

Enter

4 To enable the Hard Disk Lock

Select [Enable], then press Enter

At the [Caution], press Enter .

To disable the Hard Disk Lock

Select [Disable], then press Enter

5 Press F10 , then select [Yes]

If [Hard Disk Lock] is not displayed, contact Panasonic Technical Support.

In the default setting, [Hard Disk Lock] is set to [Disable].

You cannot set the [Hard Disk Lock] without setting the Supervisor Pass-

word. Set the Supervisor Password if you have not done so. ( page 16)

It is possible to set the Hard Disk Lock without setting the User Password,

but we recommend that you set the User Password for security reasons.

Security Measures

CAUTION

NOTE

Other manuals for Panasonic CF-27 Series