26
Computing on the Road
Enabling Power Conservation
Confirm that Phoenix APM 2.0 for Windows NT
®
is installed. (If [APM 2.0 for NT] is
displayed in [Control Panel], this means that the program is installed.) If the program is
not installed, be sure to install it.
(To install the Phoenix APM 2.0 for Windows NT
®
, execute the following procedure.
In [Start] - [Run], input [c:\util\drivers\apm\setup.exe] and select [OK]. Follow the on-
screen instructions.)
Windows NT
The LCD will be powered off.
To resume, press any key.
(On this screen, the condition the power
of the display is off is called “standby”.)
NOTE
The computer will enter the standby mode.
To resume, slide the power switch.
(On this screen, “standby” is called “sus-
pend”.)
To Next Page
Loading...
