10.3.3. Installation of indoor unit
POSITION OF SUPENSION BOLT
• Apply a joint-canvas between the unit and duct to absorb unnecessary vibration.
• Install the unit learning to a drainage hole side as a figure for easy water drainage.
INSTALLATION OF DUCT
1. The duct of the air inlet could be installed by the three situations as shown in the illustration below (a) ~ (c).
Setting the filter:
Case of (a): Reverse the filter and not install the duct of the air inlet.
Case of (b): Remove the filter (local arrangement) and install the duct of the air inlet.
Case of (c): Change the panel bottom to install the duct of the air inlet.
37
To Next Page
Loading...
