48
15.1.5. To remove the Control Board
• Release the 3 screws. (Fig. 9)
• By pressing down the hook at the left, you will be able to
remove the Control Board. (Fig. 9)
Fig. 9
15.1.6. To remove the Cross Flow Fan and Indoor Fan Motor
• Remove the screw at the Cross Flow Fan. (Fig. 10)
Reminder:-
To reinstall the Fan Motor, please adjust the connector
location is positioned 90° with Fan Motor before fixing
Control Board. (Fig. 10)
• Remove the Bearing. (Fig. 11)
• Remove the screws at the left of the Evaporator. (Fig. 11)
• Push up the Evaporator and pull out the Cross Flow Fan
from shaft. By then, Fan Motor can be taken out. (Fig. 12)
Fig. 10
Fig. 11
Fig. 12
To Next Page
Loading...
