Panasonic CS-VU18SKQ - Dust Sensor Operation

74
13.12 Dust Sensor Operation
 Depending on the level of particles detected by the dust sensor, nanoe-G generator is optimally controlled to
purify the air, thus creating a clean room environment.
 This feature is automatically turned ON when unit is operated. It is turned OFF if nanoe-G is turned ON manually.
 During the initialization (when unit is turned ON or nanoe-G is turned OFF manually), the dust sensor indicator
turns RED for 20 seconds.
 If the dust sensor detects a high level of particles, the dust sensor indicator turns RED and nanoe-G turns ON.
 If the dust sensor detects a low level of particles, the dust sensor indicator turns WHITE and nanoe-G turns OFF.
 Dust Sensor monitoring LED (Enable/Disable)
iCOMFiAUTO-XHEATCOOLDRYFAN
F
SHOWER
DIRECT
AM
PM
AM
ON
OFF
PM
Transmit
“Enable or Disable” code
Normal display mode
Control
Disable
Control
Enable
Press SW to enter customer zone &
Press SW’s to choose function 9
SET
 Dust sensor sensitivity level adjustment
iCOMFiAUTO-XHEATCOOLDRYFAN
F
SHOWER
DIRECT
AM
PM
AM
ON
OFF
PM
Transmit level code
Normal display mode
Press SW (t ≥ Osecs)
Press SW’s to choose function 11
SET
Press SW to enter customer zone &
SET
Level 1 Level 2 (Default) Level 3