45
RQT8853
[RAM]
Perform preparation steps 1−4 of “Accessing the
Management Menus” (¼ 44).
, select “Delete All
Recordings” then
ENTER
ENTER
– A message appears when deleting is fi nished.
[RAM[ [-RW‹V›] [+RW] [-RW‹VR›] [SD]
Perform preparation steps 1−4 of “Accessing the
Management Menus” (¼ 44).
to select “Yes” then
, to select “Format Disc
(DVD)” or “Format memory card”
then
ENTER
Notes
Do not disconnect the AC power supply cord while formatting. This
can render the disc or the card unusable.
When a disc or card has been formatted using this unit, it may not
be possible to use it on any other equipment.
[-R] [-R]DL] [+R] [+R]DL] [CD] Formatting cannot be performed.
[-RW‹V›] [-RW‹VR›] You can format only as DVD-Video format on this
unit.
[RAM[ Pressing [RETURN] during format will cancel the process.
The disc must be reformatted if you do this.
[RAM[ [SD[ The disc or card cannot be formatted if the write-
protect tab or switch (¼ 44) is switched to “PROTECT” or “LOCK”.
Release the protection to continue.
The message “Unable to format” appears when trying to format
discs the unit cannot use.
to complete.
Notes
Deleting does not work if one or more recordings are protected.
Formatting Discs or CardsDeleting All Recordings
ENTER
to complete.
to select “Start” then
– Formatting starts ([RAM] may take up to a
maximum of 70 minutes).
– A message appears when formatting is
fi nished.
Important: Once deleted, contents cannot be recovered. Important: Once formatted, contents cannot be
recovered.
Setting Menus
M5821.indb45M5821.indb45 2007/02/2616:38:152007/02/2616:38:15