EasyManua.ls Logo

Panasonic DMC-FZ18 - Troubleshooting; Battery and power source

Panasonic DMC-FZ18
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Others
126
VQT1G06
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you
change the mode dial to print mode [ ],
while this unit is connected to a PC. If
connecting the printer again, change the
mode to a mode other than [ ] and then
check that no data is being transferred.
([ACCESS] appears on the LCD monitor
while data is being transferred.)
[USB MODE CHANGED. PLEASE
REMOVE THE USB CABLE.]
This message will be displayed if you
change the mode dial to a mode other than
print mode [ ] while this unit and the
printer are connected.
Set the mode dial to [ ] again and then
disconnect the USB connection cable. If
printing, stop the printing and then
disconnect the USB connection cable.
[PRINTER BUSY]/[PLEASE CHECK THE
PRINTER]
The printer cannot print. Check the printer.
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P22)
w Battery and power source
1: The camera cannot be operated even
when it is turned on.
Is the battery inserted correctly?
Check the direction of the battery.
(P14)
Is the battery sufficiently charged?
Use a battery that has been
sufficiently charged.
2: The LCD monitor turns off while the
camera is turned on.
Does the picture appear on the
Viewfinder?
Press [EVF/LCD] to switch to LCD
monitor display.
Is power save mode (P20) activated?
Press the shutter button halfway to
cancel these modes.
Is the battery exhausted?
Use a battery that has been
sufficiently charged.
3: The camera turns off immediately
after it is turned on.
Is the battery charge insufficient to
operate the camera?
Use a battery that has been
sufficiently charged.
If you leave the camera on, the
battery will be exhausted. Turn the
camera off frequently by using power
save mode (P20) etc.
w Recording
1: The picture cannot be recorded.
Is the mode dial correctly set?
Is there any memory remaining on the
built-in memory or the card?
Before recording, delete some
pictures. (P33)

Table of Contents

Related product manuals