Others
130
VQT1G06
5: The picture cannot be transferred
when the camera is connected to a
PC.
• Is the camera connected to the PC
correctly?
• Is the camera recognised by the PC
correctly?
6: The card is not recognised by the
PC.
(The built-in memory is recognised.)
• Disconnect the USB connection cable.
Connect it again while the card is
inserted in the camera.
7: The picture cannot be printed when
the camera is connected to a printer.
• Does the printer support PictBridge?
• Reset the mode to [ ]. (P114)
8: The ends of the pictures are cut at
printing.
• When using a printer with a trimming or
borderless printing function, cancel this
function before printing. (For details,
refer to the operating instructions for the
printer.)
• When you order photo studios to print
pictures, ask the photo studio if the
pictures can be printed with both ends.
w Others
1: An unreadable language was
selected by mistake.
• Press [MENU/SET], select the [SETUP]
menu icon [ ] and then select the [ ]
icon to set the desired language. (P23)
2: The camera will make sounds
caused by internal mechanical
movement when it is shaken.
• The sound arises when the lens moves.
This is not a malfunction.
3: The setting for the auto review
function is disabled.
• Are you taking pictures using auto
bracket (P46)? Is the camera in burst
mode (P47) or motion picture mode
[ ] (P65)? Is [AUDIO REC.] set to
[ON] (P78)?
– In these cases, you cannot set the
auto review function in the [SETUP]
menu.
4: A red lamp sometimes turns on
when the shutter button is pressed
halfway.
• In dark places, the AF assist lamp (P82)
lights red to make it easier to focus on a
subject.
5: The AF assist lamp does not turn on.
• Is [AF ASSIST LAMP] on the [REC]
mode menu set to [ON]? (P82)
• Are you taking pictures in dark places?
– The AF assist lamp does not turn on
in bright places.
• The AF assist lamp does not turn on
when either [SCENERY] mode, [NIGHT
SCENERY], [ILLUMINATIONS] or
[CREATIVE NIGHT SCENERY] in
[NIGHT PORTRAIT] mode, or
[SUNSET], [PANNING], [FIREWORKS]
or [AERIAL PHOTO] is selected in
scene mode.
6: The camera becomes warm.
• The surface of the camera may become
warm during use. This does not affect
the performance or quality of the
camera.
7: The lens clicks.
• When the brightness changes due to
zoom or camera movement etc., the
lens may click and the picture on the
screen may drastically change.
However, the picture is not affected.
The sound is caused by the automatic
adjustment of the aperture.
This is not a malfunction.
8: The clock is reset.
• If you do not use the camera for a long
time, the clock may be reset. When the
message [PLEASE SET THE CLOCK]
appears, set the clock again. (P16)
• When you take a picture before setting
the clock, [0:00 0. 0. 0] is recorded.
9: The displayed picture is slightly
distorted.
• Depending on the zoom magnification,
the recorded picture is slightly distorted.
This is called distortion aberration. The
closer you get to the subject to take
pictures of in wide angle, the more
To Next Page
Loading...
