Basic
35
VQT1G06
3 Press / to select the picture
and then press to set.
(Only when selecting [MULTI DELETE])
• Repeat the above procedure.
• [ ] appears on the selected pictures. If
is pressed again, the setting is
cancelled.
• The icon [ ] blinks red if the selected
picture is protected and cannot be
deleted. Cancel the protect setting and
then delete the picture. (P105)
4 Press [ ].
5 Press to select [YES] and then
press [MENU/SET] to set.
(Screen when selecting
[MULTI DELETE])
• When you delete pictures, only pictures
in either of the built-in memory or the
card can be deleted. (You cannot delete
pictures in both the built-in memory and
the card at the same time.)
• [DELETE ALL PICTURES ON THE
BUILT-IN MEMORY?] or
[DELETE ALL PICTURES
ON THE MEMORY CARD?] is
displayed when using [ALL DELETE]
and [DELETE ALL EXCEPT ?] is
displayed when using
[ALL DELETE EXCEPT ].
• If you press [MENU/SET] while deleting
pictures using [ALL DELETE] or
[ALL DELETE EXCEPT ], the
deleting will stop halfway.
• Do not turn off the camera while deleting.
• When deleting pictures, use a battery with
sufficient battery power or the AC adaptor
(DMW-AC7G; optional).
• It is possible to delete up to 50 pictures at
one time using [MULTI DELETE].
• The greater the number of pictures the
longer it takes to delete them.
• If there are pictures that are protected
[ ] (P105), do not conform to the DCF
standard or are in a card with the
Write-Protect switch slid to the [LOCK]
side, they are not deleted even if
[ALL DELETE] or
[ALL DELETE EXCEPT ] is selected.
MENU
SET
To Next Page
Loading...
