Error
Code
Diagnosis contents Description Monitor Display FL display
UN-
SUPPORT
Unsupported disc error *An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally incase of the disc is dirty.
“This disc is
incompatible.”
Display for 5 seconds.
NO READ Disc read error *A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
“Cannot read.
Please check the
disc.”
HARD
ERR
Drive error The drive detected a hard error. “DVD drive error.” Display for 5 seconds.
HDD NG HDD is NG HDD is NG. Please replace HDD. No display
SELF
CHECK
Restoration operation Since the power cord fell out during a power
failure or operation, it is under restoration
operation.
*It will OK, if a display disappears
automatically. If a display does not
disappear, there is the possibility that
defective Digital P.C.B. / RAM drive.
No display
Full
Program
16 programs are already set. 16 programs are already set. No display
UN-
FORMAT
The disc is not formatted You have inserted an unformatted DVD-
RAM or DVD-RW that is unformatted or
recorded on other equipment.
If you will use this disc, format is
necessary.
But, all program recorded on this disc
will be deleted.
Format:
This disc is not
formatted properly.
Format the disc in
DISC
MANAGEMENT?
PLEASE
WAIT
Unit is in termination
process
Unit is in termination process now.
“BYE” is displayed and power will be turned
off.
In case “Quick Start” of setup menu is ON, it
is displayed in restoration operation for AC
off.
No display
18
DMR-EH80VEG / DMR-EH80VEB
To Next Page
Loading...
