Panasonic DMR-EH80VEG - PCB Removal Procedures (Continued); SD Card PCB Removal; Digital I;F PCB Removal

14.15. SD CARD P.C.B.
1. Remove Front Panel, Power Unit, Rear Panel, Hard Disc
Drive Unit, DVD-RAM Drive.
2. Disconnect 2 Connectors.
3. Remove the 2 Screws.
4. Remove SD CARD P.C.B. .
14.16. DIGITAL I/F P.C.B.
1. Remove Front Panel, Power Unit, Rear Panel, Hard Disc
Drive Unit, DVD-RAM Drive, Digital P.C.B., SD Card Unit
2. Disconnect 5 Connectors.
3. Remove the 2 Screws (A) from SD Card Angle.
4. Remove SD Card Angle together with SD Card P.C.B. .
5. Remove the 3 Screws (B) from Digital I/F P.C.B. .
6. Remove Digital I/F P.C.B. .
Note:
When inserting P.C.B. confirm correct positions of Guide
Pins.
39
DMR-EH80VEG / DMR-EH80VEB