Pictures
VQT4C71
50
Copying pictures
[SD] > [HDD]
This unit saves information about imported
pictures. Therefore, if pictures are imported from
the same SD card, then only new pictures will be
copied.
[USB] > [HDD]
All pictures in USB will be copied.
1 While stopped
Insert the SD card or the USB memory.
The menu screen appears. (> 31)
2 Select “Copy Pictures ( JPEG )”, then press
[OK].
3 Select “Copy”, then press [OK].
• [SD] Even if protection of the card is set,
copy will start.
• [USB] Copy will start.
4 [SD]:
Select “Copy & Delete” or “Copy Only”, then
press [OK].
If “Copy & Delete” is selected, copied
pictures in the SD card will be deleted after
copying.
To stop copying
Press and hold [RETURN ] for 3 seconds.
• Pictures without shooting date will be categorised using the
creation date.
• If the space on the destination drive runs out or the number
of files/folders to be copied exceeds the maximum (> 95),
copying will stop partway through.
• This unit saves the information on up to 12,000 pictures
and 30 SD cards. If additional pictures are imported, the
older information will be deleted.
[HDD] ,-. [RAM] [SD]
[SD] ,-. [RAM]
[USB] > [HDD] [RAM]
1 While stopped
Press [FUNCTION MENU].
2 Select “Copy (VIDEO / PICTURE)” in “Copy”,
then press [OK].
3 Set the copy direction.
1 Select “Copy Direction”, then press
[1] (right).
2 Set “Source”.
3 Set “Destination”.
4 Press [2] to confirm.
4 Set the copy mode.
1 Select “Copy Mode”, then press
[1] (right).
2 Set “Format” to “PICTURE”.
3 Press [2] to confirm.
Copying automatically
To Next Page
Loading...
