125
UF-9000
APR 2006
Ver. 3.0
DP-180/190
4.7.2. Jam Error Codes (J Code)
Section Jam Location
AADF
B Paper Transport / Exit Area
C Paper Entry Area
Jam Error Codes (J Codes) Table
Code Contents Section
J00 The Registration Sensor did not detect paper within a predetermined time after paper
started feeding. (Sheet Bypass)
C
J01 The Registration Sensor did not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (1st Feeder Unit)
J02 The Registration Sensor does not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (2nd Feeder Unit)
J43 Paper Jam in the Registration Sensor or Paper Path Sensor.
B, C
J44 Paper Jam in the Paper Exit / ADU Paper Jam Sensor.
J70 Read Point Sensor does not go ON within 10 seconds after the original starts feeding.
(Information Code 030 is printed on the Transaction Journal instead.)
A
J71 Original was longer than 78.7 in (2m).
(Information Code 031 or 032 is printed on the Transaction Journal instead.)
J80 The Automatic Duplex Unit (ADU) Entrance Sensor does not detect paper within a
predetermined time.
C
J82 The ADU Exit Sensor does not detect paper within a predetermined time after ADU
Middle Sensor is activated.
J83 The ADU Entrance Sensor keeps detecting paper after a predetermined time has
lapsed.
J92 The Original was pulled out when feeding an original.
A
J93 The Original remained in the ADF.
To Next Page
Loading...
