Panasonic DP-180

274
UF-9000
APR 2006
Ver. 3.0
DP-180/190
8.3. Installing the Printer Controller Module for PS / PCL6
(DA-MC190: UF-9000; DA-MC188: DP-180/190)
8.3.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
8.3.2. Installation
1. Before installing this option, make sure the Program Expansion Board (DA-EM600) is installed
into (CN327) [Lower] on the SC PC Board first. Refer to the Installation Instructions of the
Program Expansion Board (DA-EM600).
2. Install the Hardware Key by following the steps below.
CAUTION!
Turn the Power Switch on the Left Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord.)
Qty. Description Remarks
1 Hardware Key PS KEY
1 Software CD Includes Operating Instructions
1 Adobe PostScript 3 Label
1
License Agreement
For USA and Canada only
1 For Adobe PostScript Driver
1 Installation Instructions This document
(1) Remove the Rear Paper Tray Cover.
(2) Remove 5 Silver Screws.
(3) Remove the Right Cover.