Panasonic DP-180

276
UF-9000
APR 2006
Ver. 3.0
DP-180/190
8.4. Installing the Hard Disk Drive Unit (DA-HD19)
8.4.1. Contents
8.4.2. Installation
1. Before installing the Hard Disk Drive Unit, make sure the optional Sorting Image Memory is
installed in the memory socket on the SC PC Board first. At least an additional 16 MB
(DA-SM16B) of Sorting Image Memory is required.
Refer to the Installation Instruction of the Sorting Image Memory (DA-SM16B/64B/28B).
2. For UF-9000, V2.xxxxx or higher SC firmware is required. Update the Firmware referring to the
Service Notes “Firmware Update”.
3. Install the Hard Disk Drive Unit by following the steps below.
CAUTION!
Turn the Power Switch on the Left Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord.)
Qty. Description Part No. Remarks
1
Hard Disk Drive (HDD) See Note
1 DC PCB DZEC103051
1 HDD Bracket DZJC000389
1 HDD Harness DZFP001565 Flat Cable
1 DC Harness DZFP001566 Power Supply Cable
1 Edge Saddle DZJK000057 Black-Square
3 Harness Clamp (Small) DZJK000004 Black
3 Harness Clamp (Medium) DZJK000067 White
6 Screw (Short) XTB3+4F
2 Screw (Medium) XTW3+6LFC
1 Firmware CD DZHP010773 For USA version only (UF-9000)
1 Installation Instructions See Note This document
(1) Remove the Rear Paper Tray Cover.