Panasonic DP-180

266
UF-9000
APR 2006
Ver. 3.0
DP-180/190
The Firmware in the table below are not interchangeable.
Firmware for machines with Serial No. prefix CF [March 2006] and above for USA/Canada (may differ for
other destinations). (Navy Blue Control Panel), cannot be used on machines with Serial No.
prefix BF [February 2006] and below for USA/Canada (may differ for other destinations).
(Light Blue Control Panel).
Note:
1. Manual mode must be used, when updating the designated version of the firmware or changing
the type of the firmware.
Please refer to the Section 2.2, "Setting up the Network Firmware Update Tool, File Selection
Tab" of the Operating Instructions.
2. While updating the firmware code, the display may become garbled, however, it will return to
normal upon completion of the firmware update.
3. If the firmware update fails, and the unit does not boot up, the Network Firmware Update Tool will
not be able to transfer the firmware code. If this occurs, please refer to the next section
"Updating through the USB Port", and use the Local Firmware Update Tool to recover the unit.
4. The suffix "_xx" for the Folder Name or File Name may not exist depending on the destination
location.
Parent Firmware File Folder Sub Firmware File Folder User
Authentication
Transferring Order
\ UF-9000_AUR_xxxxxx
(Navy Blue Control Panel)
\ SC_STD \ DX-TrirAxVxxxxx_xx
X1
\ SC_PCL \ DX-TrirBxVxxxxx_xx
X1
\ SC_PS \ DX-TrirDxVxxxxx_xx
X1
\ SPC \ DX-TRI-SAxVxxxxx
2
\ UF-9000_AU_xxxxxx
(Light Blue Control Panel)
\ SC_STD \ DX-TriAxVxxxxx_xx
1
\ SC_PCL \ DX-TriBxVxxxxx_xx
1
\ SC_PS \ DX-TriDxVxxxxx_xx
1
\ SPC \ DX-TRI-SAxVxxxxx
2
\ DP-190_180_xxR_xxxxxx
(Navy Blue Control Panel)
\ SC_STD \ DP-TrirAxVxxxxx_xx
X1
\ SC_PCL \ DP-TrirBxVxxxxx_xx
X1
\ SC_PS \ DP-TrirDxVxxxxx_xx
X1
\ SPC \ DX-TRI-SAxVxxxxx
2
\ DP-190_180_xx_xxxxxx
(Light Blue Control Panel)
\ SC_STD \ DP-TriAxVxxxxx_xx
1
\ SC_PCL \ DP-TriBxVxxxxx_xx
1
\
SC_PS \ DP-TriDxVxxxxx_xx
1
\ SPC \ DX-TRI-SAxVxxxxx
2
When you select the Parent Folder, the following Firmware Type
window appears. Proper Sub File Folders are selected automatically
by selecting the Firmware Type.
The transferring order is set up automatically.