Panasonic EP-MA03

22
6.11. Error code List
If there are any malfunction on each Sensors, each Motors, and power source and data communication lines in the operations, the
following displays blink and the all the operations stop.
Use them for the reference in the repair.
*1 You need to operate the Secret mode to remove the errors of F04 to F06, and F08.
(Users cannot remove the errors.)
However, you can move up and down the Ottoman/Reclining lift units.
Error code Malfunction Possible reasons Notes
F04 Heater error
(Thermistor disconnection)
Heater unit error (Thermistor disconnection) * 1
F05 Heater error
(Thermistor short-circuit)
Heater unit error (Thermistor short-circuit) * 1
F06 Heater error
(Trisistor short-circuit)
Sub PCB error (Trisistor short-circuit) * 1
F08 Heater sensor wire short-
circuit error
Heater unit error (Heater sensor wire short-circuit) * 1
F11 Data communication error Connector connection error of Connecting PCB, Sub
PCB, and Controller, Connecting cord disconnection,
damage parts, etc.
F12 Sub PCB MPU frequency
sensor error
Sub PCB error
F33 Tapping sensor Sensor connector coming-off, Lead disconnection,
parts damage, Connecting cord for power source dis-
connection, Sub PCB relay error, etc.
F34 Ottoman sensor Connector coming-off, Lead disconnection, parts dam-
age, Sub PCB relay error
F35 Reclining sensor Connector coming-off, Lead disconnection, parts dam-
age, Sub PCB relay error
F36 Massaging (width) sensor Sensor connector coming-off, Lead disconnection,
parts damage, Connecting cord for power source dis-
connection, Sub PCB relay error, etc.
F37 Up/down sensor Sensor connector coming-off, Lead disconnection,
parts damage, Connecting cord for power source dis-
connection, Sub PCB relay error, etc.
F15 Ottoman motor Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error.)
F16 Reclining motor Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error.)
F14 Tapping motor Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error(F33).)
F80 Massaging motor Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error(F36).)
F81 Up/down motor Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error(F37).)