15
5.9. Checking after assembly [CA]
Check if the Massage mechanism block is properly assembled or there is nothing wrong with the Sensors or Motors.
* Detect failures in Sensors or Motors.
1. Proceed the procedures of 5.1. Preparation of Secret Mode.
2. Push the button of BACK INTENSITY till CA appears, and push the OK button.
3. Massage mechanism block starts operating. If there is nothing wrong, it stops normally.
4. If you stop the operation halfway, push the buttons of Off/On or Stop on the Controller.
5.10. Adjustment of Body pressure sensor [CC].
1. Proceed the procedures of 5.1. Preparation of Secret Mode.
2. Push the button of BACK INTENSITY till CC appears, and push the OK button.
3. Push the OK button again.
Caution: Be careful to check if there is no pressure applied on both right and left Massage balls and push the OK but-
ton.
If the OK button is pushed with the pressure on the Massage balls, it may cause the malfunction that shoulder posi-
tion is not accurate in sensing.
4. Push the Off/On button on the Controller. The adjustment is done.
To Next Page
Loading...
